Ian,
Give Matt @ Race brakes a call, and see if he can set you up with the 355mm C5 twin piston kit. They may actually work with your existing uprights and the caliper is a lot better than the previous generation PBR that the Cebco kit runs (they are the same as the T-series basic setup as well as ELGT)
Failing that, you could splash out on the BAI/II FPV Standard setup, with the "newer" C6 caliper and 325 x 32mm rotor (Cebco's are 330 x 28mm). These calipers are better than what you have and the pads are isolated from the caliper sliding pins to dampen/reduce any shudder that the earlier calipers had. The only downside here is that the AUII onwards front suspension will still require fitment.
For the rears, you can just buy the Territory rear setup from a wrecker, or Matt had a special on them for around $600-700. These rears measure 328 x 16mm from memory, and are a ventilated rotor and are standard fitment on FPV. They are more than sufficient.
Daniel
|