The newly updated MTM PF22.2 Foam Cannon has just gone on sale in the USA, Australia hopefully following closely behind. This represents MTM finally listening to the calls for a wide mouth bottle.
https://www.mtmhydroparts.com/collec...-2-foam-cannon
https://www.mtmhydroparts.com/collec...-bottle-3-pack
image
image
image
image
Now, I have been running these foam cannons for three years now. The key benefit of these foam cannons over others is the more efficient consumption of the soap solution. This is something I have verified side by side with an older Waxit branded foam cannon, which goes through the contents of the bottle considerably faster. And yet, even with the added efficiency, you still get exceptional foam from the MTM.
image
image
image
image
image
But like any product, there was room for improvement. The earliest versions of the PF22 had a sexy looking bottle……………that would tip over if not completely full of liquid. MTM partially addressed this with the 22.2 update, the bottle reshaped to be wider at the bottom to prevent it tipping over. And yet…………………..it still tipped over when empty. This stems from the heft and bulk of the FP22 cannon body, which is much chunkier than key rivals.
image
image
image
image
Another irk was the lack of a wide mouth bottle to make filling easier. I will say, I have never had a wide mouth bottle foam cannon, so I have always managed with the FP22.2’s narrow opening. The key to success is to fill the bottle with water first, then add the soap at the end. There were also complains of the plastic bottle not threading nicely with the brass foam cannon body, although I have never really had much problem.
image
image
image
With the latest update to the PF22.2, MTM have redesigned the bottle to have a wide mouth and a bayonet fitting. Retooling for a new foam cannon body would have been very expensive, so MTM designed a plastic adaptor to mate the old brass body to the new bottle. Some have complained that this is a half-assed approach, but take a look at the competition……………they are doing the same thing. My only concern would be the durability of the bayonet fitting.
Now, at the moment, in the USA MTM are only offering the new PF22.2 as a full assembly, along with replacement wide mouth bottles. I have been told that there will be the ability to convert an older PF22.2 via the adaptor and replacement bottle. At the moment, I can’t find those on the MTM Veloci website as standalone parts.
image
image
image
As it stands, I won’t be buying another PF22.2 foam cannon, I already have two that would be a prime candidate for the upgraded parts. So, in addition to selling the new units in full, here’s hoping the local retailers stock the required parts for a conversion.