|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
04-05-2010, 09:06 PM
|
#1 | ||
|
V8 AU Fairlane
Join Date: Aug 2008
Location: Nambucca Heads
Posts: 153
|
How do you remove the abs module? I cant find my workshop manual so i am stuck. I need to remove it to send it away to be repaired! Is there another thread on this. I tried to remove the fuse box but it wont move far. Thanks Pete.
|
||
|
|
|
04-05-2010, 10:50 PM
|
#2 | ||
|
FF.Com.Au Hardcore
Join Date: Nov 2008
Location: Melbourne, Vic
Posts: 1,121
|
if you are talking about what i think you are it is the abs module which sits between the radiator overflow and the battery.
There is one in the pic below.  I have only pulled them off to sell have never put one back on though. You can undo the 2 nuts on either side of it one on the fuse box side and one on the rear side at the top. These hold it into the mounting bracket. There is also a rubber bush down under it which may be catching (may require a decent tug). Then just unplug the wire loom. And all of the brake lines to it. (Think they are 13mm. Be careful to not round them off at all. Hope this helps Cheers, Rhys
__________________
AU III Forte wagon - V8, 5spd man, lowered, 18" Honeycombs, Stock diff rebuilt with TruTrac LSD, Leather Ghia interior/dash, custom twin 2.5" into single 3" exhaust. Wagon Build AU I Forte Sedan - No longer
Toy Car Build |
||
|
|
|
|
05-05-2010, 10:52 AM
|
#3 | ||
|
V8 AU Fairlane
Join Date: Aug 2008
Location: Nambucca Heads
Posts: 153
|
If i disconnect the brake lines wont i have to then bleed the brakes?
|
||
|
|
|
|
05-05-2010, 03:09 PM
|
#4 | ||
|
Fast Lanes Inc.
Join Date: Jun 2007
Location: Brisbane
Posts: 15
|
Hey check to find out if they need the whole unit, some places only need the electronics module (Black plastic part) which can be separated from the hydraulic unit by undoing the connector and 6 torx screws. Have a look at absrepair.com.au/faq.htm this shows how they only need the electronics in most cases. Saves ripping out the whole thing.
__________________
AU V8 Fairlane, Extractors, Magnaflow Cats, Twin 2.5" Custom Exhaust, BA Brakes, Lowered, Koni Adjustables, Nolathane, MSD Ignition, CAI, EL GT Momo Steering wheel. |
||
|
|
|
ABS module removal
Hybrid Mode