Adams Polishes



Welcome to the Australian Ford Forums forum.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact us.

Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated.

Go Back   Australian Ford Forums > Club and Speciality Forums > Forum Community Car Clubs > OzECruisers (E/N/D Series) > OzECruisers General Discussions

OzECruisers General Discussions E/N/D vehicles General Discussion ONLY. NO TECH THREADS

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 31-03-2007, 02:19 PM   #1
snypereb
[EBGLT]
 
snypereb's Avatar
 
Join Date: Sep 2005
Location: Cazza Dee
Posts: 4,829
Tech Writer: Recognition for the technical writers of AFF - Issue reason: Writing tech article(s) 
Default EBGLT Dyno'd.

Ok guys here it is.
Took the car down to Hallam performance today with Paul fom CVE. First run was not so good it ran 122rwkw which I was pretty disapointed and a little worried I must admit.

Paul soon jumped out of the car and said you have a vaccuum leak which alternately means boost leak. So I got up under the and worked my wonders turned out that there where a few minor leaks here and there. Out of the tree at the back of the inlet manifold.

Sliding across under the engine I had a look at the wastegate which look good until I touched the the srcew which holds the vaccuum hosing which controls my boost level. It was loose as so after hunting around hallam performance for 10 mins we found some washers that would fit however are on temporary as I need better ones that need to be a little smaller and tighter around the thread.

Here is the last Dyno for the day.

As you can see 163.6rwkw was acheived at only 3psi which is insane im over the moon about it.
Cant wait till I get a few little things here and there sorted out and I can wynd in a bit more boost. hehe. :

SnyperEB

__________________
[EBGLT]

Become an E-Series Owners Club Member Today!
http://eseries.com.au/index.php/membership/
snypereb is offline   Reply With Quote Multi-Quote with this Post
 


Forum Jump


All times are GMT +11. The time now is 12:16 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Other than what is legally copyrighted by the respective owners, this site is copyright www.fordforums.com.au
Positive SSL