|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| OzECruisers General Discussions E/N/D vehicles General Discussion ONLY. NO TECH THREADS |
 |
|
|
Thread Tools | Display Modes |
24-11-2006, 11:34 AM
|
#1 | ||
|
Starter Motor
Join Date: Nov 2006
Posts: 2
|
Hi,
I bought some clear indicators for my EA, and I was wondering how do I put them on? I'm pretty car illiterate, so this is gonna be a challange haha. From what I can see, I have to take the headlights out to swap them over, correct? But when I've undone all the bolts that are holding the headlights in, it won't come out. Is this because the bumper is in the way, or is there an easier way of doing this? Thanks. |
||
|
|
|
24-11-2006, 11:50 AM
|
#2 | ||
|
Regular Member
Join Date: Nov 2006
Location: Chambers Flat, QLD
Posts: 183
|
There's 4 bolts on each light. 2 visible from the front, 1 under the light bulb cap at the back and 1 on the side where the grill would be when the bonnet is closed. These all off, everything unplugged and they should slide straight out. If it doesn't slide out, then just check that it's not getting caught on your bumper (which mine did as the bumper wasn't aligned properly). Then there is only 3 screws holding the indicator to the light. That should be it
|
||
|
|
|
|
24-11-2006, 01:03 PM
|
#3 | ||
|
ED4LYFE
Join Date: Mar 2006
Location: North Coast NSW
Posts: 301
|
Yeah Mine got caught as well, i just borrowed a steak knife from the kitchen and pushed the rubber on the bottom up while bringing it out
Check the FordMods.com website, also deleted link has a good guide on how to do it. I followed the guide and done the headlights in about 40minutes, clear repeaters took 10minutes or so each One thing though, MAKE SURE you leave enough room for them to clip back on to the metal prong, I looked at the pic and thought mine was enough however you can still take them out so I used a little bit of stikaflex to make sure they stay on (not enough that I can't get it off it bulb breaks)
__________________
giggity |
||
|
|
|
Using Clear Indicators
Linear Mode
