|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
OzECruisers General Discussions E/N/D vehicles General Discussion ONLY. NO TECH THREADS |
|
Thread Tools | Display Modes |
01-06-2005, 01:51 PM | #1 | ||
Turbo Dinosaur FTMFW
Join Date: Dec 2004
Location: SA
Posts: 7,834
|
hey guys, as i'm pulling the I6 + 4spd auto out of my EB to replace them with a 5.0 + T5, i have to figure out which driveshaft and gearbox crossmember i can use.
can i use the ones i've already got? if not, what else fits? do i have to get original EB V8 parts? doing these conversions on x-series cars is so much easier, everythings the same for 6's and 8's... |
||
01-06-2005, 04:58 PM | #2 | ||
Two > One
Join Date: Dec 2004
Location: Adelaide
Posts: 7,063
|
afailk crossmember is the same as well as the drive shaft.
__________________
1978 LTD - 408ci - 11.5@120.6mph - 2004 S4 - 4.2 - M6 - quattro - |
||
01-06-2005, 07:40 PM | #3 | |||
FF.Com.Au Hardcore
Join Date: Dec 2004
Posts: 1,381
|
I am using an EL XR8 auto tailshaft in my manual ef6 so I reacon youll be right there. Was using an XF crossmember for a while as well.
I would be very surprised if the x-members were different
__________________
Quote:
|
|||