|
03-09-2013, 02:35 PM | #1 | ||
_Oo===oO_
Join Date: Dec 2004
Location: Australia
Posts: 3,305
|
Hi all,
I'm after some advice on clearing leaves out of the heating/cooling ducting. I remember this being somewhat easy on an EA, with two points of access: pull the exterior cowling off (after detaching the windscreen wiper) and pulling out the glovebox to reach a duct. Is this the same on AU's? Any other tips on getting to the leaves/stopping them getting in? Cheers, |
||
08-09-2013, 01:07 AM | #2 | ||
FF.Com.Au Hardcore
Join Date: Feb 2005
Location: Melb north
Posts: 12,025
|
I was told , it is possible to remove the resistor on the left side of the heater box with the glove box out and shove a flexible bit of tube on the end of a vacuum nozzle, though a have not tried it, i believe someone on here did try it a found it hard going,
but knowing what a sod of a job it is to get the heater box out, personally, i would try that and be a bit inventive in the nozzle department first. |
||
This user likes this post: |