|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
23-12-2015, 10:39 AM
|
#1 | ||
|
Starter Motor
Join Date: Feb 2013
Posts: 2
|
Hello.
I have not used the fuel side of my au for a long time. Stuck to gas almost exclusively but now the gas is now playing up so going back to fuel, it needed some attention. I replaced my fuel pump and removed and cleaned my injectors and fuel rail. tons of crap came out of the fuel rail. Now after reassembling, my car is barely running. Fuel and smoke coming out the exhaust and running so rough. Can anyone suggest what i might have done to cause this? I don't think I put any injector leads onto the wrong injector but is there an easy way to check which lead suits which injector? I thought I kept them approximately in line. Also probably not relevant but the fuel line popped off on first startup, and gave the the underbody a good splash and i also changed the thermostat. Any suggestions would be greatly appreciated. Thanks Last edited by schpud; 23-12-2015 at 10:47 AM. Reason: added info |
||
|
|
|
24-12-2015, 08:46 AM
|
#2 | ||
|
Regular Member
Join Date: Oct 2013
Posts: 35
|
hey mate, check to make sure you have put the vac hose back on the fuel pressure reg.
|
||
|
|
|
|
25-12-2015, 10:57 AM
|
#3 | ||
|
Starter Motor
Join Date: Feb 2013
Posts: 2
|
Thanks for the suggestion. Yes it had been reconnected. Spent a bit of time checking everything was reconnected, then took everything apart again. I removed the fuel rail and started to pull injectors. Once I had pulled 1 out and the pressure changed 1 of the other injectors started spraying fuel. Looks lit after cleaning and re-kiting it packed it in. Once I get some more injectors and swap it out I will post here to say if it fixed it. Might be helpful to someone else in the future.
|
||
|
|
|
AU series 1 serviced injectors, blowing smoke and running rough
Linear Mode
